I specifically did not use air tools, to show the process. A lot of people only have basic tools and this can be accomplished with standard tools. See List below. This is a 9 min time-lapse video of the 1 1/2 hrs it took to completely strip down and disassembly of a 2009 Chevy Full Floating 14B rear axle for my One (1) Ton Axle swap into my 2009 JKU.
The contents of the video are almost ALL of the current maintenance and installation videos within the It’s a Jeep World YouTube Channel.
Using a Double line winch pull method with a snatch block can when properly accomplished give you 2x the pulling power of your winch.
Compliments Riley Harshman the Owner of the Jeep and who provided the information, check out his WAYALIFE Thread “Birth of Phoenix” The main question you have to ask yourself when researching this swap, “Do you go with a Fuel cell, aftermarket tank or do the TJ fuel tank swap?” A Fuel Cell takes up needed …
Read more “How To – JK/JKU Fuel Tank Relocation / TJ Fuel Tank Swap”
Explanation of what you need to do to actually be able to remove your freedom top panels and hardtop. Bolts to remove, levers to move, latches to unlatch, connectors to disconnect, etc.. This video has a hoist system which is used. Manual removal is explained as well.Shout outs to https://www.facebook.com/IG4wlusa/, https://www.sevenslotsociety.com/, http://onthetrailpodcast.com/ w/Kevin and Scott. …
Front ends shakes, wobbles, shimmies and the dreaded Death Wobble. These have been going on since steering was invented and has worsened with the incorporation of coil spring suspensions. Prevention is the key to any well maintained Jeep. Preventive Maintenance and Routine Inspections and not of just the Stereo Equipment. We used a Floor Jack, …
Read more “Death Wobble Prevention – A Simple and Effective Suspension Inspection”
Parts Recommended:Upper and Lower Intake Gaskets – MS97204Oil Filter/Cooler Housing – 68105583AE Tools Required: 8mm Socket 10mm Socket Ratchet 3” and 6” extensions Body Clip Tool T20 Torx T30 Torx E8 (External) Torx Small flat tip screwdriver Standard Pliers Wide Tape to cover intake ports Brake Cleaner or similar, to clean intake and oil filter/cooler …
Tools Needed: 10mm Wrench, 14 mm Wrench, 16mm Wrench, 18mm Wrench, 18mm Socket, 19mm Wrench, 19mm Deep Well Socket, 7/8″ Wrench, 13/16″ Socket, 21mm Wrench, 21mm Socket, 7/16″ Wrench, 9/16″ Wrench, 9/16″ Socket, 33mm Socket, Jack, (4) 6 ton Jack Stands, (2) 3 ton Jack stands, 13/32″ Drill bit, Drill, Pitman Arm Puller, PB Blaster, …
Jeep Wrangler JK JKU Pinion Bearing Removal and Replacement Refer to JK_JKU Hub Bearing Replacement video for more detailed instructions on removal and Installation of the Hub Bearing and Axle Shaft. https://youtu.be/9uOOXPxBr8M Tool Suggested: 1/2″ Drive Ratchet 1/2″ Drive Breaker Bar 1/2″ Drive Torque Wrench capable of 120 ft lbs 3/8″ Drive Ratchet 1/4″ Drive …
Read more “How to – Remove and Replace the Pinion Bearing on a Jeep Wrangler JK JKU and others”
