This is a How-to video for converting your square headlights to round headlights. The Jeep in the video is a 1987 Grand Wagoneer, these techniques will probably work on other vehicles with square headlights.
This is a complete tear down, clean and rebuild of a 1987 Grand Wagoneer Power Mirror Controller Switch. I was able to make the switch work again. The weak link is the center section which the adjusting knob is pressed into, this piece is made of a material that is brittle and over time and use cracks and breaks apart, rendering the adjusting knob useless because it is no longer attached. This might work for your controller switch or similar controller switches, it also might not.
I specifically did not use air tools, to show the process. A lot of people only have basic tools and this can be accomplished with standard tools. See List below. This is a 9 min time-lapse video of the 1 1/2 hrs it took to completely strip down and disassembly of a 2009 Chevy Full Floating 14B rear axle for my One (1) Ton Axle swap into my 2009 JKU.
Compliments Riley Harshman the Owner of the Jeep and who provided the information, check out his WAYALIFE Thread “Birth of Phoenix” The main question you have to ask yourself when researching this swap, “Do you go with a Fuel cell, aftermarket tank or do the TJ fuel tank swap?” A Fuel Cell takes up needed […]
Do It Yourself – Simple Step by Step Instructions on How to Remove and Replace The Oil Filter / Cooler Assembly on your 2012 and Newer Jeep Wrangler using common tools
Parts Recommended:Upper and Lower Intake Gaskets – MS97204Oil Filter/Cooler Housing – 68105583AE Tools Required: 8mm Socket 10mm Socket Ratchet 3” and 6” extensions Body Clip Tool T20 Torx T30 Torx E8 (External) Torx Small flat tip screwdriver Standard Pliers Wide Tape to cover intake ports Brake Cleaner or similar, to clean intake and oil filter/cooler […]
Tools Needed: 10mm Wrench, 14 mm Wrench, 16mm Wrench, 18mm Wrench, 18mm Socket, 19mm Wrench, 19mm Deep Well Socket, 7/8″ Wrench, 13/16″ Socket, 21mm Wrench, 21mm Socket, 7/16″ Wrench, 9/16″ Wrench, 9/16″ Socket, 33mm Socket, Jack, (4) 6 ton Jack Stands, (2) 3 ton Jack stands, 13/32″ Drill bit, Drill, Pitman Arm Puller, PB Blaster, […]
Jeep Wrangler JK JKU Pinion Bearing Removal and Replacement Refer to JK_JKU Hub Bearing Replacement video for more detailed instructions on removal and Installation of the Hub Bearing and Axle Shaft. https://youtu.be/9uOOXPxBr8M Tool Suggested: 1/2″ Drive Ratchet 1/2″ Drive Breaker Bar 1/2″ Drive Torque Wrench capable of 120 ft lbs 3/8″ Drive Ratchet 1/4″ Drive […]
I had to fabricate a heat shield because mine on my JKU was missing. I had to replace the starter because of heat damage, it is about ¾” from a catalytic converter. This is the heat barrier which has adhesive on the back and what I used to protect the metal I used for the […]
This is specifically for Iron Rock Offroad Adjustable Control Arms – After installation and testing has occured, it is time to adjust for better performance. This process is similar for most adjustable control arms, clamping nuts and bolts may differ but the procedure is the same.